Chevrolet Cruze Owners Manual: Engine Cooling System Messages
A/C OFF DUE TO HIGH ENGINE TEMP
This message displays when the engine coolant becomes hotter than the normal operating temperature.
To avoid added strain on a hot engine, the air conditioning compressor automatically turns off.
When the coolant temperature returns to normal, the air conditioning compressor turns back on. You can continue to drive the vehicle.
If this message continues to appear, have the system repaired by your dealer as soon as possible to avoid damage to the engine.
ENGINE OVERHEATED — IDLE ENGINE
This message displays when the engine coolant temperature is too hot. Stop and allow the vehicle to idle until it cools down.
ENGINE OVERHEATED — STOP ENGINE
This message displays and a continuous chime sounds if the engine cooling system reaches unsafe temperatures for operation.
Stop and turn off the vehicle as soon as it is safe to do so to avoid severe damage. This message clears when the engine has cooled to a safe operating temperature.
HIGH COOLANT TEMPERATURE
This message displays if the coolant temperature is hot.
Door Ajar MessagesDOOR(S) OPEN A vehicle symbol will be displayed on the DIC showing which door is open along with this message. Close the door completely. HOOD OPEN This message will display when the hood is ope ...
Engine Oil MessagesCHANGE ENGINE OIL SOON This message displays when the engine oil needs to be changed. When you change the engine oil, be sure to reset the Oil Life System. OIL PRESSURE LOW — STOP ENGINE This mess ...
Rear Side Door Check Replacement
Preliminary Procedure Remove rear side door trim panel. Refer to Rear Side Door Trim Replacement Remove the rear side door water deflector. Refer to Rear Side Door Water Deflector Replacement Rear Side Door Check Bolt Caution: Refer to Fastener Caution in the Pre ...
Brake System Warning Light
The vehicle brake system consists of two hydraulic circuits. If one circuit is not working, the remaining circuit can still work to stop the vehicle. For normal braking performance, both circuits need to be working. If the warning light comes on, there is a brake problem. Have the brake system ...
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System.