Chevrolet Cruze Owners Manual: Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn.
An arrow on the instrument cluster will flash in the direction of the turn or lane change.
Raise or lower the lever until the arrow starts to flash to signal a lane change. The turn signal flashes three times.
The lever returns to its starting position when it is released.
If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb may be burned out. Replace any burned out bulbs. If a bulb is not burned out, check the fuse.
Hazard Warning Flashers(Hazard Warning Flasher): Press and momentarily hold this button on the instrument panel above the climate control system, to make the front and rear turn signal lamps flash on and off. This ...
Front Fog LampsFor vehicles with front fog lamps, the button is on the outboard side of the instrument panel. The ignition must be on to turn on the fog lamps. (Front Fog Lamps): Press to turn the fog lamps ...
Hood Caution: Refer to Fastener Caution in the Preface section. Procedure Loosen the hood hinge reinforcement nuts (Qty: 4). Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the front bumper fascia and so that the hood ...
Floor Air Outlet Replacement
Removal Procedure Remove the instrument panel assembly. Refer to Instrument Panel Assembly Replacement. Remove the instrument panel wiring harness (2) from the instrument panel tie bar (1). Disconnect the electrical connectors. Remove the instrument panel tie bar ...
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System.