Mazda 3 Service Manual: Relay Block Inspection [With Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Driver-side front scuff plate.
b. Driver-side front side trim.
c. Hood release lever.
d. Upper panel.
e. Shift knob (MTX)(See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R].)(See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [A26M-R].)
f. Selector lever knob (ATX)(See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)
g. Shift panel.
h. Side wall.
j. Lower panel.
k. Knee bolster.
3. Remove the relay block..
4. Verify that the continuity is as indicated in the table.
If not as indicated in the table, replace the relay block.
Restraints SST [Two Step Deployment Control System]
49 H066 002 Deployment tool 49 D066 002 Adapter harness 49 L066 002 Adapter harness 49 G066 003 Adapter harness 49 N088 0A0 Fuel and Thermometer checker ...
Inspecting Washer Fluid Level WARNING Use only windshield washer fl uid or plain water in the reservoir: Using radiator antifreeze as washer fl uid is dangerous. If sprayed on the windshield, it will dirty the windshield, aff ect your visibility, and could result in an a ...
Proper lifting and towing are necessary to prevent damage to the vehicle. Government and local laws must be followed. A towed vehicle usually should have its drive wheel (front wheels) off the ground.