Nissan Sentra Service Manual: Evaporative emission system
1.CHECK EVAP CANISTER
- Block port (B).
- Blow air into port (A) and check that it flows freely out of port (C).
- Release blocked port (B).
- Apply vacuum pressure to port (B) and check that vacuum pressure exists at the ports (A) and (C).
- Block port (A) and (B).
- Apply pressure to port (C) and check that there is no leakage.
>> INSPECTION END
Ignition timingInspection 1.CHECK IGNITION TIMING Attach timing light to the ignition coil No.1 harness. Check ignition timing. : Timing indicator Specification : EC-486, "Ignition Timing" > ...
Evap leak checkInspection CAUTION: Do not use compressed air or a high pressure pump. Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: Do not start engine. Improper ...
With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on: If equipped, the following lights come on briefly and then go off: If any light fails to come on, it may indicate an open circuit ...
Illumination control switch signal circuit
Diagnosis procedure Regarding wiring diagram information, refer to mwi-28, "wiring diagram". 1.Check combination meter input signal Turn ignition switch on. Check voltage between the following terminals of the illumination control switch. Is the inspection result normal? ...
P2101 Electric throttle control function
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P2101 is displayed with DTC P2100, first perform the trouble diagnosis for DTC P2100. Refer to EC-423, "DTC Logic". If DTC P2101 is displayed with DTC P2119, first perform the trouble diagnosis for DTC P2119.