Toyota Camry: Programming a Rolling Code system (for U.S. owners)
If your device is Rolling Code equipped, follow the steps under the heading “Programming HomeLink®” before proceeding with the steps listed below.
- Locate the learn button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener motor for the location of the learn button.
- Press the learn button.
Following this step, you have 30 seconds in which to initiate step 3 below.
- Press and hold the vehicle’s programmed HomeLink® button for 2 seconds and then release it. Repeat this step once again. The garage door may open.
If the garage door opens, the programming process is complete. If the door does not open, press and release the button a third time.
This third press and release will complete the programming process by opening the garage door.
The ceiling mounted garage door opener motor should now recognize the HomeLink® signal and operate the garage door.
- Repeat the steps above to program another rolling code system for any of the remaining HomeLink® buttons.
Programming the HomeLink®Point the remote control transmitter for the device 1 to 3 in. (25 to 75 mm) from the HomeLink® control buttons. Keep the HomeLink® indicator light in view while programming. Press and ...
Problems with the sliding sunroof
Your vehicle may be equipped with a sliding sunroof or a panorama roof with power tilt/ sliding panel.