Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

Toyota Highlander Service Manual: Brake master W/Plate cylinder sub-ASSY

REPLACEMENT

HINT:COMPONENTS: See page 32-18 .

1. REMOVE FRONT SUSPENSION BRACE SUB-ASSY UPPER CENTER

REMOVE FRONT SUSPENSION BRACE SUB-ASSY UPPER CENTER


(a) Remove the 4 nuts and the front suspension brace subassy upper center.

2. REMOVE AIR CLEANER ASSY (2AZ-FE ENGINE TYPE) (SEE PAGE 14-24 )

3. REMOVE AIR CLEANER CAP SUB-ASSY (3MZ-FE ENGINE TYPE) (SEE PAGE 14-149 )

4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSY (3MZ-FE ENGINE TYPE) (SEE PAGE 14-149 )

5. REMOVE AIR CLEANER CASE (3MZ-FE ENGINE TYPE) (SEE PAGE 14-149 ) 6. DRAIN BRAKE FLUID

NOTICE: Wash brake fluid off immediately if it adheres to any painted surface.

7. REMOVE BRAKE MASTER W/PLATE CYLINDER SUB-ASSY

REMOVE BRAKE MASTER W/PLATE CYLINDER SUB-ASSY


(a) Using SST, disconnect the 2 brake tubes from the brake master w/plate cylinder sub-assy.

SST 09023-00101

(b) Disconnect the brake fluid level warning switch connector.

REMOVE BRAKE MASTER W/PLATE CYLINDER SUB-ASSY


(c) Remove the 2 nuts, then pull at the check valve bracket and the brake master w/plate cylinder assy.

8. INSPECT AND ADJUST BRAKE BOOSTER PUSHROD

NOTICE: Make an adjustment with the brake booster assy having no vacuum. (Depress the brake pedal several times with the engine stopped.)

HINT: Adjustment of the brake booster push rod is performed when the brake master cylinder sub-assy is replaced with a new one.

The adjustment is not necessary when the brake master cylinder sub-assy is reinstalled and the brake booster assy is replaced with a new one.

(a) Apply the chalk to the tip of an accessory tool.

HINT: An accessory tool is enclosed with a new brake master cylinder sub-assy .

 INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD


(b) Place the accessory tool to the brake booster assy.

(c) Measure the clearance between the brake booster push rod and accessory tool.

Clearance: 0 mm (0 in.)

HINT: Adjust the clearance in following cases:

  • If there is a clearance between the accessory tool and the shell of the brake booster (floating accessory tool), the push rod is protruding too far.
  • If the chalk does not stick on the tip of the brake booster push rod, the push rod protrusion is insufficient.

 INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD


(d) If clearance is outside the specified range, fix the push rod using SST and adjust the length of the protruding adjusting bolt.

SST 09737-00020

HINT: When adjusting the push rod, depress the brake pedal sufficiently so that the push rod sticks out.

9. INSTALL BRAKE MASTER W/PLATE CYLINDER SUB-ASSY

INSTALL BRAKE MASTER W/PLATE CYLINDER SUB-ASSY


(a) Install the brake master w/ plate cylinder sub-assy and the check valve bracket with the 2 nuts.

Torque: 13 NVm (130 kgfVcm, 9 ftVlbf)

INSTALL BRAKE MASTER W/PLATE CYLINDER SUB-ASSY


(b) Using SST, connect the 2 brake tubes to the brake master w/ plate cylinder assy.

SST 09023-00101

Torque: 15 NVm (155 kgfVcm, 11 ftVlbf)

(c) Connect the brake fluid level warning switch connector.

10. FILL RESERVOIR WITH BRAKE FLUID (SEE PAGE 32-4 )

11. BLEED MASTER CYLINDER (SEE PAGE 32-4 ) SST 09023-00101

12. BLEED BRAKE LINE (SEE PAGE 32-4 )

13. BLEED BRAKE ACTUATOR ASSY (SEE PAGE 32-4 )

14. CHECK FLUID LEVEL IN RESERVOIR (SEE PAGE 32-4 )

15. INSTALL AIR CLEANER ASSY (2AZ-FE ENGINE TYPE) (SEE PAGE 14-24 )

16. INSTALL AIR CLEANER CASE (3MZ-FE ENGINE TYPE) (SEE PAGE 14-149 )

17. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSY (3MZ-FE ENGINE TYPE) (SEE PAGE 14-149 )

18. INSTALL AIR CLEANER CAP SUB-ASSY (3MZ-FE ENGINE TYPE) (SEE PAGE 14-149 )

19. INSTALL FRONT SUSPENSION BRACE SUB-ASSY UPPER CENTER

INSTALL FRONT SUSPENSION BRACE SUB-ASSY UPPER CENTER


(a) Install the front suspension brace sub-assy upper center with the 4 nuts.

Torque: 80 NVm (816 kgfVcm, 59 ftVlbf)

20. CHECK BRAKE FLUID LEAKAGE

21. CHECK FLUID LEVEL IN RESERVOIR (SEE PAGE 32-4 )

Brake pedal sub-assy
ADJUSTMENT 1.

Related news

  • Mazda 3 Service Manual: Steering Gear And Linkage RemovalInstallation
  • Subaru Legacy: Effect vehicle modifications made for persons with disabilities may have on SUBARU advanced frontal airbag system operation (U.S. only)
  • Hyundai Sonata: Engine startstop button position
  • BMW 5 Series: Rear CDDVD player
  • Nissan Sentra Owners Manual: Automatic door locks

  • Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY

    Toyota Highlander Service Manual: Brake master WPlate cylinder sub-ASSY