Toyota RAV4 Service Manual: Ts and cg terminal circuit
If the vehicle is stationary during sensor check mode, speed sensor malfunctions cannot be detected. The vehicle must be driven for speed sensor malfunctions to be detected.
Change to sensor check mode by connecting terminals tc and cg of the dlc3, and turning the ignition switch from off to on.
- Check wire harness (dlc3 - skid control ecu and body ground)
- Disconnect the a27 ecu connector.
- Measure the resistance of the wire harness side connectors.
Replace abs and traction actuator assembly
Tc and cg terminal circuitDescription Connecting terminals tc and cg of the dlc3 causes the skid control ecu to display 2-digit dtcs by flashing the abs warning light. Wiring diagram Inspection procedure Check dl ...
Downhill assist control indicator light remains on
Description When the downhill assist control switch is pushed on, the downhill assist control function is available and the downhill assist control indicator light illuminates. Hint: Even if the downhill assist control switch is pressed, the downhill assist control indicator light will blink ...
Install ignition switch assembly Install the ignition switch with the 2 screws. Install the ignition key cylinder light connector. Install the ignition switch connector. Install steering column cover lower Attach the 4 claws to install the steering column l ...
Using the “setup” menu (“phone” menu)
Functions and operation procedures To enter the menu for each function, press the “setup” button and follow the steps below using the “tune•scroll” knob: Adding a new phone number 1. Phone 2. Phonebook 3. Add contacts Setting speed dials 1.