Toyota Sienna Service Manual: For vehicles equipped with mobile communication systems
FOR VEHICLES EQUIPPED WITH MOBILE COMMUNICATION SYSTEMS
(a) Install the antenna far away from the ECU and sensors of the vehicle electronic systems as possible.
(b) Install an antenna feeder at least 20 cm (7.87 in.) away from the ECU and sensors of the vehicle electronic systems. For details about ECU and sensors locations, refer to the section on the applicable components.
(c) Keep the antenna and feeder separate from other wirings as much as possible. This will prevent signals sent from the communication equipment from affecting vehicle equipment and vice-versa.
(d) Check that the antenna and feeder are correctly adjusted.
(e) Do not install any high-powered mobile communication system.
Handling of hose clampsHANDLING OF HOSE CLAMPS (a) Before removing the hose, check the clamp position so that it can be reinstalled in the same position. (b) Replace any deformed or dented clamps with new ones. ...
1. CHECK BATTERY VOLTAGE Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge the battery before proceeding. 2. CHECK DLC3 (a) The ECU uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 f ...
Catalyst System Efficiency Below Threshold
DTC P0420 Catalyst System Efficiency Below Threshold (Bank 1) DTC P0430 Catalyst System Efficiency Below Threshold (Bank 2) MONITOR DESCRIPTION The ECM uses the sensors mounted in front of and behind the three-way catalyst (TWC) to monitor its efficiency.