Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

DTC B1154/38 Rear Airbag Sensor RH Circuit Malfunction

DESCRIPTION

The rear airbag sensor RH circuit consists of the center airbag sensor assembly and rear airbag sensor RH.

If the center airbag sensor assembly receives signals from the rear airbag sensor RH, it judges whether or not the SRS should be activated.

DTC B1154/38 is recorded when a malfunction is detected in the rear airbag sensor RH circuit.

DESCRIPTION

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 CHECK DTC

CHECK DTC

  1. Turn the ignition switch to the ON position, and wait for at least 60 seconds.
  2.  Clear the DTCs stored in memory.
  3.  Turn the ignition switch to the LOCK position.
  4. Turn the ignition switch to the ON position, and wait for at least 60 seconds.
  5.  Check the DTCs.

OK: DTC B1154/38 is not output.

HINT: Codes other than code B1154/38 may be output at this time, but they are not related to this check.

USE SIMULATION METHOD TO CHECK

2 CHECK CONNECTION OF CONNECTORS

  1. Turn the ignition switch to the LOCK position.
  2.  Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
  3.  Check that the connectors are properly connected to the center airbag sensor assembly and the rear airbag sensor RH.

OK: The connectors are connected.

3 CHECK FLOOR WIRE NO. 2 (OPEN)

CHECK FLOOR WIRE

  1. Disconnect the connectors from the center airbag sensor assembly and the rear airbag sensor RH.
  2. Using a service wire, connect A22-19 (VUCR) and A22- 20 (ESCR) of connector "B".

    NOTICE: Do not forcibly insert a service wire into the terminals of the connector when connecting.

  3.  Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

CHECK FLOOR WIRE

  1. Using a service wire, connect A22-18 (CSR+) and A22-4 (CSR-) of connector "B".

    NOTICE: Do not forcibly insert a service wire into the terminals of the connector when connecting.

  2.  Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

4 CHECK FLOOR WIRE NO. 2 (SHORT TO B+)

CHECK FLOOR WIRE NO. 2

  1. Disconnect the service wire from connector "B".
  2.  Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
  3.  Turn the ignition switch to the ON position.
  4. Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

5 CHECK FLOOR WIRE NO. 2 (SHORT TO GROUND)

CHECK FLOOR WIRE NO. 2

  1. Turn the ignition switch to the LOCK position.
  2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
  3.  Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard voltage

6 CHECK FLOOR WIRE NO. 2 (SHORT)

CHECK FLOOR WIRE NO. 2

  1. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

7 CHECK REAR AIRBAG SENSOR RH

CHECK REAR AIRBAG SENSOR RH

  1. Connect the connector to the center airbag sensor assembly.
  2.  Interchange the rear airbag sensor LH with RH and connect the connectors to them.
  3.  Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
  4.  Turn the ignition switch to the ON position, and wait for at least 60 seconds.
  5.  Clear the DTCs stored in memory.
  6.  Turn the ignition switch to the LOCK position.
  7.  Turn the ignition switch to the ON position, and wait for at least 60 seconds.
  8.  Check the DTCs.

Result

Result

HINT: Codes other than DTC B1154/38 and B1155/39 may be output at this time, but they are not related to this check.

USE SIMULATION METHOD TO CHECK

Other materials:

Installation
1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER (a) Insert the tire pressure warning valve and transmitter into the valve installation hole. Insert it from the inside of the rim so that the printed surface can be seen. NOTICE: Check that there is no visible deformation, damage, ...

Removal
HINT:  Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2.

Related news

  • BMW 5 Series: Bypassing a section of the route
  • Mazda Mazda6: Steering Wheel
  • Chevrolet Sonic Owners Manual: Dinghy Towing All except RS Model with Automatic Transmission
  • Toyota Sienna Service Manual: Radio antenna cord
  • HD Radio indicators

  • Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction

    Toyota Sienna Service Manual: Rear Airbag Sensor RH Circuit Malfunction