Toyota Sienna Service Manual: Rear wheel alignment

Toyota Sienna Service Manual: Rear wheel alignment

ADJUSTMENT

NOTICE: For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally: 1. Disconnect the negative battery terminal for more than 2 seconds.

2. Reconnect the negative battery terminal.

3. Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection.

HINT: (See page BC-70)

1. INSPECT TIRE

HINT: (See page TW-2)

2. MEASURE VEHICLE HEIGHT

NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified valve.

3. INSPECT TOE-IN

(a) Inspect the toe-in.

INSPECT TOE-IN

Toe-in

FF

4WD

HINT: If the toe-in is not within the specified value, inspect the suspension parts and replace them if necessary.

4. INSPECT CAMBER

(a) Install the camber-caster-kingpin gauge or position the vehicle on the wheel alignment tester.

(b) Inspect the camber.

Camber

FF

4WD

HINT: If the measured value is not within the specified value, inspect the suspension parts for damage and the wear and replace them if necessary because camber is not adjustable.

Front wheel alignment
Adjustment NOTICE: For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the ...
Other materials:

Diagnosis system
1. CHECK DLC3  The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and meets the ISO 15765-4 format. NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the igniti ...

Removal
1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat). Remove the rear seatback board.  Remove the rear seat shoulder belt cover.  Remove the 2 bolts, 2 nuts and No.

Related news

  • Toyota Tacoma Owners Manual: Emission inspection and maintenance (IM) programs
  • Chrysler 200: Driver And Passenger Advanced Front Air BagInflator Units
  • Nissan Altima: Changing engine coolant
  • Buick LaCrosse: Recalling RKE Memory Positions (Memory Remote Recall)
  • Kia Optima: Operation of the rear parking assist system

  • Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment

    Toyota Sienna Service Manual: Rear wheel alignment