Toyota Sienna Service Manual: Speaker Circuit

Toyota Sienna Service Manual: Speaker Circuit

DESCRIPTION

  •  When the vehicle has a built-in type amplifier, a sound signal is sent from the radio receiver to the speakers via the "6 Speaker System" circuit.
  •  When the vehicle has a separate type amplifier, a sound signal from the radio receiver is amplified by the stereo component amplifier and then transmitted to the speaker via the "10 Speaker System" circuit.

If there is a short in this circuit, the stereo component amplifier detects it and stops output to the speakers.

Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier or speakers

WIRING DIAGRAM

WIRING DIAGRAM

WIRING DIAGRAM

WIRING DIAGRAM

1 CHECK HARNESS AND CONNECTOR

CHECK HARNESS AND CONNECTOR

  1. Disconnect the connectors shown in the illustration from the stereo component amplifier or radio receiver and speakers.
  2.  10 Speaker System: Measure the resistance between each of the front No. 2 speakers and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

  3.  6 speaker System: Measure the resistance between each of the front No. 2 speakers and the radio receiver to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

  4.  Measure the resistance between each of the front No. 2 speakers and each of the front No. 1 speakers to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

  5.  10 Speaker System: Measure the resistance between each of the rear speakers and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

  6.  6 Speaker System: Measure the resistance between each of the rear speakers and the radio receiver to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

  7.  10 Speaker System: Measure the resistance between each of the rear stereo component speakers and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

  8.  10 Speaker System: Measure the resistance between the front stereo component speaker and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

CHECK HARNESS AND CONNECTOR

  1. 10 Speaker System: Measure the resistance between the woofer box speaker and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance: Below 1 Ω

  2.  Measure the resistance between the each speaker and body ground to check for a short circuit in the wire harness.

    Standard resistance: 10 kΩ or higher

2 INSPECT FRONT NO. 1 SPEAKER

  1. Resistance check.
  1.  Measure the resistance between the terminals of the speaker.

    Standard resistance: 10 Speaker System: 4 to 6 Ω
    6 Speaker System: Approximately 4 Ω

3 INSPECT REAR SPEAKER

  1. Resistance check.
  1. Measure the resistance between the terminals of the speaker.

    10 Speaker System: Approximately 2.4 Ω
    6 Speaker System: Approximately 4 Ω

4 INSPECT FRONT NO. 2 SPEAKER

  1. Check that the malfunction disappears when another speaker in good condition is installed.

    Standard: Malfunction disappears.

HINT:

  •  Connect all the connectors to the front No. 2 speaker.
  • When there is a possibility that either the right or left front speaker is detective, inspect by interchanging the right one with the left one.
  •  Perform the above inspection on both LH and RH sides.

5 CONFIRM MODEL

Result

Result

6 INSPECT WOOFER BOX SPEAKER

INSPECT WOOFER BOX SPEAKER

  1. Resistance check.
  1. Measure the resistance according to the value(s) in the table below.

NOTICE: The speaker should not be removed for checking.

Standard resistance

Standard resistance

7 INSPECT REAR STEREO COMPONENT SPEAKER

  1. Check that the malfunction disappears when another speaker in good condition is installed.

OK: Malfunction disappears.

HINT:

  •  Connect all the connectors to the rear stereo component speaker.
  •  When there is a possibility that either the right or left rear speaker is detective, inspect by interchanging the right one with the left one

8 INSPECT FRONT STEREO COMPONENT SPEAKER

  1. Resistance check.
  1. Measure the resistance between the terminals of the speaker.

    Standard resistance: 1.2 to 2.2 Ω

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Illumination Circuit
DESCRIPTION Power is supplied to the radio receiver and steering pad switch illumination when the light control switch is in the TAIL or HEAD position. WIRING DIAGRAM INSPECTION PROCEDURE N ...
Other materials:

Assist grips
Type A An assist grip installed on the ceiling can be used to support your body while sitting on the seat. Type B An assist grip installed on the pillar can be used when getting in or out of the vehicle and others. WARNING Type A: Do not use the assist grip when g ...

Rear blower resistor
ON-VEHICLE INSPECTION 1. INSPECT REAR BLOWER MOTOR CONTROLLER (a) Measure resistance according to the value(s) in the table below.. Standard resistance If the resistance is not as specified, replace the rear blower motor controller. (b) Inspect the rear blower motor controller. (1 ...

Chassis
GENERAL MAINTENANCE 1. INSPECT STEERING LINKAGE (a) Check the steering linkage for looseness or damage. Check that: Tie rod ends do not have excessive play. Dust seals and boots are not damaged. Boot clamps are not loose. (b) Inspect the dust cover for damage. 2.

Related news

  • Toyota Sienna 2010-2018 Owners Manual: The Blind Spot Monitor function
  • Mazda 3 Owners Manual: Rear View Monitor Operation
  • Nissan Rogue Service Manual: The parking brake release warning continues sounding, ordoes not sound
  • Mazda 3 Service Manual: Map Light RemovalInstallation
  • Toyota Corolla Owners Manual: Using the interior lights

  • Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit

    Toyota Sienna Service Manual: Speaker Circuit