Toyota Sienna Service Manual: Vehicle Position Mark is not Updated
1 CHECK MAP DISC
- Check that the map disc is not deformed or cracked.
OK: No deformations or cracks on map disc.
2 CHECK MAP DISPLAY
- Check if a touch scroll can be performed on the map display.
OK: Touch scroll can be performed
3 CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
- Enter the "Navigation Check" mode (Vehicle Sensors).
- While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.
OK: The readings are almost equal.
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NOTICE: The Vehicle Identification Number (VIN) must be input into the replacement ECM. HINT: The VIN is a 17-digit alphanumeric vehicle identification number. The intelligent tester is required to register the VIN. 1. INPUT INSTRUCTIONS The general VIN input instructions using the ...
No. 1 Speaker with box
COMPONENTS ON-VEHICLE INSPECTION 1. INSPECT NO.1 SPEAKER WITH BOX HINT: Remove interior parts so that the No.1 speaker with box can be seen. Check the speaker installation. OK: The speaker is securely installed. If the result is not as specified, reinstall the No.1 s ...
Rear wiper motor and bracket
COMPONENTS REMOVAL 1. REMOVE REAR WIPER ARM Remove the rear wiper arm head cap from the rear wiper arm. Remove the nut and the rear wiper arm. 2. REMOVE BACK DOOR GARNISH CENTER 3. REMOVE BACK DOOR SIDE GARNISH LH 4. REMOVE POWER BACK DOOR ROD 5.